The adaptive security appliance supports browsing of the following groups: Traps for the logical and physical interfaces are displayed.
When the Ethernet 0/1 interface is up, the ASA sends traps about the two logical interfaces that are assigned to this physical interface. When the Ethernet 0/1 interface is down, the ASA sends traps about the two logical interfaces that are assigned to this physical. Traps for physical interfaces (that is, Ethernet 0/0 and Ethernet 0/1) are also displayed. At bootup, the ASA sends link state traps only on interfaces that were configured with a nameif command (that is, VLAN interfaces). coldstart : The ASA is running after a reload. linkdown : An interface is down, for example, if you removed the nameif command. linkup : An interface has transitioned to the “up” state. authentication: An SNMP request fails because the NMS did not authenticate with the correct community string. The adaptive security appliance sends the following SNMP core traps: SNMP server statistics are obtained by executing "show snmp-server statistics" sw8-5520(config)# sh snmp-server statisticsĠ Illegal operation for community name suppliedĠ Too big errors (Maximum packet size 512) 5 ::= Unable to allocate system block to construct PDU.Ģ12005: incoming SNMP request (%d bytes) from %s exceeds data buffer size, discarding this SNMP request.Ģ12006: Dropping SNMP request from %I/%d to %s:%I/%s because: %sħ10005: %s request discarded from %A/%d to %s:%A/%dħ10002: %s access permitted from %A/%d to %s:%A/%s 4 ::= PDU length exceeds supported UDP segment size. 3 ::= Unable to set destination address in UDP. #Cisco snmp mib view family name vpn monitor code#
14 ::= Unable to determine source address from UDP.Ģ12004: Unable to send an SNMP response to %s, error code = %d 7 ::= Incoming request exceeds supported buffer size. 5 ::= Received 0 bytes from UDP channel. 3 ::= Unable to set the trap channel as write-only.Ģ12003: Unable to receive an SNMP request on interface \"%s\", error code = %d, will try again. 2 ::= Unable to bind to the UDP channel.
1 ::= Unable to open a UDP channel on the trap port. Thread will automatically attempt to re-establish a listener on the defaultĢ12002: Unable to open SNMP trap channel (UDP port %d) on interface \"%s\", error code = %d 1 ::= Unable to establish a listener on the configured port.Ĭommunication with hosts in the snmp-server config is not possible. The following syslogs messages are generated by SNMP: 212001: Unable to open SNMP channel (UDP port %d) on interface \"%s\", error code = %d The following information is provided as a suppliment to the information found in the ASA Configuration guide, and the SNMP MIB Browser.
0 kommentar(er)
